Harbor Freight Tools 219 User Manual - Page 6

Grease Loading Instructions Warning!! Make sure the Grease Gun is not attached to the air source hose when loading grease. Grease can be loaded into the Grease Gun by loading with a filler pump (FIGURE 1), using suction filling (FIGURE 2), or loading with a cartridge (FIGURE 3). Loading a grease cartridge (not included). See the Assembly Drawing on page 10, Figures A, B, and C on page 5 and FIGURE 3 below. 1. Remove the Tube (18) from the top of the Front Housing (7). 2. Pull back on the Handle (21) until it is fully extended. Lock it into place with the Locking Plate (20). 3. Remove the caps/lids from both ends of the cartridge (not included). Insert the cartridge into the Tube (18) in the orientation indicated on the cartridge, making sure that it is in as far as possible. 4. Reassemble the Tube (18) to the top on the Front Housing (7). Press the Locking Plate (20) and release the Handle (21). Press the Handle (21) in as far as it will go. FIGURE 1 FIGURE 2 FIGURE 3 Filler Hose with Plug on the Pump (not included) enters the Nozzle (10) Cartridge Nozzle (10) Tube (18) Filler Pump Filling Suction Filling Cartridge Filling Suction Filling (FIGURE 2) See the Assembly Drawing on page 10, Figures A, B, and C on page 5 and FIGURE 2 above. 1. Remove the Tube (18) from the top of the Front Housing (7). 2 Submerge the open end of the Tube (18) approximately 2 inches into the grease container (not included). 3. Slowly, pull back and fully extend the Handle (21) to draw grease upward into the Tube (18). When the Handle (21) is fully extended, lock it into place with the Locking Plate (20). 4. Carefully, reassemble the Tube (18) to the top on the Head (7). Press the Locking Plate (20) and release the Handle (21). Press the Handle (21) in as far as it will go. SKU 00219 For technical questions, please call 1-800-444-3353. REV 05g Page 6